// MAME Controller: Installing the buttons and controls

1. Begin to install the buttons, trackball, and spinner.

2. Install the I-Pac and Opti-Pac to the box set aside for the CP.

3. Install the 13” fluorescent light to the bottom of the CP box where room allows. Run the plug through a hole drilled in the back.

4. Once completed, turn the panel over and begin to wire the controls.

a. Using 22 gage solid wire and female slider connectors, solder the connections together after they are made.

b. Wire the ‘normally open’ (NO) to the I-Pac and wire the ground daisy-chained to each control.

c. Wire the trackball and spinner to the Opti-Pac.

d. Test the connections with a computer keyboard and the mouse interfaces (spinner and trackball)

e. Once accepted, remove the temporary bolts, replace the surface of the CP with the CP box and secure the box with the four bolts.